Blue foam sections cut on the hot wire. Each section is numbered and was cut around a card section of the stencil shown below. As the hand-held power sander proved too
vigorous to use on blue foam, I have began to hand-sand the pieces to a
uniform thickness on a sanding block. The edges will be rounded off for a softer finish.
Card template for the wings. I have decided to make these larger from my original test pieces and straighter at the middle joint. This template will double up for the reverse side of the wings to ensure symmetry.
Blue foam sections cut on the hot wire. Each section is numbered and was cut around a card section of the stencil shown below. As the hand-held power sander proved too vigorous to use on blue foam, I have began to hand-sand the pieces to a uniform thickness on a sanding block. The edges will be rounded off for a softer finish.
Card template for the wings. I have decided to make these larger from my original test pieces and straighter at the middle joint. This template will double up for the reverse side of the wings to ensure symmetry.
No comments:
Post a Comment